11.
Unscrew nut (3) to the end of the shaft and secure
nut (3) with cotter pin (2).
12.
Reinstall rubber boot (11) and safety plate (20).
IMPORTANT: This procedure does not cover the checking
of the parking brake pad wear. It is the operator's
responsibility to check this on a regular basis. The brake
pads must be replaced if the remaining thickness is less
than 1mm.
TRAVELLING - PARKING BRAKE Hydraulic
9691 1 27/05/2004
D.32.C / 11
6
ZDA4707B
7
ZDA5080A