3.
Remove the valve cover (1) and O-ring (2). Remove
the cam ring (3). Lift the cylinder block (5) from the
bearing support shaft (6) and remove the O-ring (4).
4.
To disassemble the cylinder block first inspect
the splines (1) in the cylinder block for excessive
wear or damage. Inspect lapped surface (2) of
block for damage. Remove retaining clip (5), piston
retainers (3) and piston assembly (4). In the event
that a retainer clip breaks while removing it from
the cylinder block use a 10-32 tap, small ball peen
hammer and adjustable wrench to remove it.
IMPORTANT: Do not reuse piston retaining clip. Inspect
pistons for excessive wear pattern.
TRAVELLING - REAR AXLE
9687 1 27/05/2004
D.12.A / 26
3
20042861
4
20042865