Hydrostatic Motor - Install (D.12.A.28 - F.10.A.15) - Case IH AFX8010 Repair Manual

Hydrostatic motor - Install (D.12.A.28 - F.10.A.15)

AFX8010
1. To install new pivot pin bushings(1) in the motor
use special tool (Bushing Installer) (2) (3) until the
bushing is pressed flush into the housing.
IMPORTANT: Be sure the holes in the bushing align with
the holes in the housing.
IMPORTANT: Be sure not to damage the bushing bores
or the bushing when installing.
2. With the bushings installed place the C-frame (2) on
a flat surface. Prepare the motor wheel flange(1)
in a sling using a hoist to lift the motor over the
C-frame.
3. Apply Loctite Brand 454 to smooth side of
thrust washer (5) and install on motor. Install
environmental seal (4) on motor housing with seal
lips toward motor. Coat the seals with grease.
Install seal covers (3) over environmental seals.
Apply Loctite Brand 515 around holes and threads
on top and bottom ears of C-frame. Install C-frame
(2) onto motor. Install and torque M6 capscrews (1)
to 9 - 11 Nm (7 - 14 lb ft) to hold seal covers to top
and bottom ears of C-frame.
TRAVELLING - REAR AXLE
9687 1 27/05/2004
D.12.A / 41
1
20041984
2
20015310A5
3
20041978