Case IH AFX8010 Repair Manual page 1460

12. Place plate (1) on top of can, flat side up. Put a
friction disk (1) , plate (3) , and another friction disk
(2) over the shaft. Carefully assemble piston (4)
over shaft. Piston must be aligned over dowel pins
and through disks and plates. When in place, the
ear on the middle plate will be held when pressing
on the top of the piston. Place the return spring (5)
over the shaft with the lip down and inserted in the
spring fingers.
13. Compress the return spring and ring. Install
retaining ring on shaft. Be sure snap ring is fully
seated before releasing press.
POWER TRAIN - PROCESS DRIVE Primary process drive
9683 1 27/05/2004
C.50.B / 12
12
10035846A5
13
10041900