Case IH AFX8010 Repair Manual page 2091

Drive system Drive and gear - Leakage test (K.40.C.40.44 - F.40.A.40)
AFX8010
•
1. In order to prevent any leak of oil perform the
following test: Using a plug on the input shaft side
of the gearbox place a pressure gauge. Be sure
the gauge is sealed good around the threads with
thread sealant. Use a gauge capable of reading
0 - 207 kPa ( 0 - 30 psi ) increments accurately.
Using the plug in the housing on the shift fork side
of the gearbox induce service air into the gearbox to
pressurize it to 0.35 bar (5 psi ). By watching the
gauge or by using a manometer (scale about 0.6
bar) watch for a pressure drop over a ten minute
period, this will verify seal integrity of the gearbox
for leaks.
CROP PROCESSING - THRESHING Axial flow threshing
9714 1 27/05/2004
K.40.C / 21
1
10041864
2
10041865