Case IH AFX8010 Repair Manual page 1508

13. Apply a light coating of grease on O-ring (1) and
install O-ring (1) in ring gear (2).
14.
Install inner final drive housing (1) onto ring gear.
15. Apply thread locking compound type 1 (Loctite 242)
to bolts (1). Screw in twelve bolts (1) and lock
washers. Torque to 320 Nm (236 lb ft).
16. Install bearing (1). Apply a load of 150 kg (330 lb)
on the bearing cone back face (1) and turn final
drive around the output shaft to correctly seat the
bearing cone. Measure distance X between the
cone back face of bearing (1) and the upper flat
surface of the output shaft.
IMPORTANT: Be sure the 12 bolts (1) are tightened to
specified torque before measuring distance X. Measure
distance X with the load applied on the bearing cone back
face.
NOTE: The required shim pack can be defined as follows:
Shim pack = X - 0.35 mm (X - 0.014").
TRAVELLING - FRONT AXLE
9686 1 27/05/2004
D.10.A / 28
12
zda43622a
13
zda46382a
14
zda46392a
15
zda4163b