Case IH AFX8010 Repair Manual page 1770

BODY AND STRUCTURE - ENVIRONMENT CONTROL Heating, ventilation and air-conditioning
11. Using a shaft protector, tap the front plate to the
shaft until it has bottomed to the clutch shims.
12.
Replace the shaft hex nut and torque to 35 - 4 Nm
(26 - 30 lb ft).
13. Check the air gap with a feeler gauge 0.4 - 0.8 mm
(0.016 - 0.032 in). If the air gap is not consistent
around the circumference, lightly pry up at the
minimum variations. Lightly tap down at points of
maximum variation.
Next operation: Install the compressor. Compressor - Install (E.40.D.31 - F.10.A.15)
9702 1 27/05/2004
E.40.D / 26
7
20018372
8
20018373