Case IH AFX8010 Repair Manual page 1434

11. Install the opposite bearing cap (1) into the yoke
bore. Place the assembly into a vise (2) so that
the bearing caps can be squeezed inward. Apply
steady pressure on the vise and press the caps
onto the trunnion until the caps are flush with yoke
bores on each side.
IMPORTANT: The bearing caps must be properly aligned
in the yoke bores or they will bind. The caps should slide
into the yoke with only moderate force. If excessive force
is needed to move the caps, they are misaligned - remove
from the vise and realign the caps in the bores.
IMPORTANT: While the bearing caps are moving into
the yoke, rotate the cross to maintain alignment of the
needles in the cap. At no point should the cross bind in
the caps. If it does bind, this indicates that a needle is
out of alignment or the cap is crooked in the yoke bore.
Remove from the vise and check the cap and needle
alignment. On occasion, the caps may stick in the bores
even though they are aligned properly. It is acceptable to
tap the yoke with a soft face hammer to ease the caps into
the bores as pressure is applied by the vise.
12. Loosen the vise and install a solid plug over one
bearing cap. Place the yoke and plug back into the
vise and tighten to push one cap in far enough to
expose the retaining ring groove in the yoke bore.
13.
Remove the yoke from the vise and install the
retaining ring (1) into the yoke bore (2). Be sure that
the ring is fully seated in the groove.
14. Put a solid plug over the opposite bearing cap end
and place the yoke and plug into a vise. Apply
pressure to the vise to push the cap in far enough to
expose the retaining ring groove in the yoke bore.
IMPORTANT: While the bearing cap is moving into the
yoke, rotate the cross to maintain alignment of the needles
in the cap. At no point should the cross bind in the caps. If
it does bind, this indicates that a needle is out of alignment
or the cap is crooked in the yoke bore. Remove from the
vise and check the cap and needle alignment.
15. Remove the yoke from the vise and install the
retaining ring into the yoke bore. Be sure that the
ring is fully seated in the groove.
POWER TRAIN - FRONT PTO Mechanical
9682 1 27/05/2004
C.42.B / 8
10
20034665B
11
20034659B