7.
Place the crown gear (1) on the bearing.
8.
Place the output shaft (1) in the crown gear (2) using
a mallet. Place the bearing (3) on the output shaft.
9.
Place the O-ring on the cover (1). Place the cover
(1) on the gearbox. Install the M10x35 bolts and
lock washers on the cover. Torque to 44 - 49 Nm
(32.5 - 36.25 lb ft). Install the outer race of the
bearing, shims, spacer and the snap ring. Adjust
number of shims to remove any play of the shaft.
10.
Check the gear backlash using a dial gauge. Add or
remove shims under the crown gear as necessary
to achieve a backlash of 0.15 - 0.25 mm (0.006 -
0.010 in).
POWER TRAIN - FRONT PTO Mechanical
9682 1 27/05/2004
C.42.B / 19
7
10040111A5
8
10033807A5
9
10040112A5
10
10040113