5.
Connect the drive lines (1) and the speed sensor (2)
to the gearbox (3).
6.
Torque the 1-1/2" bolt (1) to 1054 Nm (775 lb ft).
7.
Install the cap (1).
8.
Install the floor section (1) by lifting the back end
into the feeder first. Once the entire floor is in the
feeder, slide it forward, and bring the back down,
then slide it into position. Secure in place with the
bolts, washers and nuts (2).
CROP PROCESSING - FEEDING Feeder housing
9712 1 27/05/2004
K.25.E / 23
5
50032030A5
6
50040157A5
7
10032085A5
8
10032083A5