Case IH AFX8010 Repair Manual page 1236

8. Apply Loctite 242 to hex socket head cap screws
(1) and tighten them. Torque to 50 - 60 Nm (37
- 44 lb ft)
9.
Install a dial gauge (2) in the gearbox housing and
locate the probe perpendicular against the side of
gear (1). Apply a load in one direction and oscillate
the shaft several times while the load is applied.
Set the dial gauge to zero. Apply the load in the
opposite direction, oscillate and read the axial
movement of the shaft. Make three measurements
at 120 degrees of the input shaft. The average of
the readings should be 0 - 0.03 mm (0 - .001 in) .
If required, adjust the shims. To decrease the axial
movement, decrease the number of shims.
NOTE: Be sure to measure on gear (1) as the other gears
are mounted on needle bearings.
10. Install selector fork (1).
11. Install oil baffle plate (1). Install bolts (2). Torque the
M8 bolts to 23 - 26 Nm (17 - 19 lb ft) .
POWER TRAIN - TRANSMISSION Mechanical
9680 1 27/05/2004
C.20.B / 46
8
Zda3339b
9
3436a
10
3437a
11
3440a