Case IH AFX8010 Repair Manual page 1514

Half-shaft - Remove (D.10.A.43 - F.10.A.10)
AFX8010
1. Remove the bolts and nuts from the outer and
inner drive shaft couplers . Slide both couplers (1)
completely outward, over the transmission and final
drive shafts.
2. Slide the drive shaft completely toward the final
drives, and slide the retaining ring from the groove to
the smallest shaft diameter at the transmission end.
NOTE: Be careful to not over expand retaining ring during
remove, to avoid excessive yielding and ring damage.
3. Slide the drive shaft completely towards the
transmission and slide the snap-ring from the
groove to the smallest diameter at the final drive
end.
NOTE: Be careful to not over expand retaining ring during
remove, to avoid excessive yielding and ring damage.
4. Push both couplers, fully onto the drive shaft.
5.
Remove the drive shaft assembly.
6. Remove the coupler and rings over the splined end
of shaft. Do not remove retaining rings unless they
will be replaced.
7. Repeat for the opposite side.
TRAVELLING - FRONT AXLE
9686 1 27/05/2004
D.10.A / 34
1
20036405A5
2
50021343