Case IH AFX8010 Repair Manual page 1178

7. Bolt Ground Drive Hydro Pump mounting flange (1)
over the shaft using four washers and bolts. Torque
to 89 - 100 Nm (66 - 74 lb ft). Check rolling torque.
Nominal range should be 0.2 - 1.2 Nm (2 - 11 lb in).
Add or remove shims to obtain the desired rolling
torque. Remove the flange, shaft and shims from
the gearbox and set aside.
Bolt Triple Gear Pump mounting flange (2) over
the shaft using six washers and bolts. Torque to
89 - 100 Nm (66 - 74 lb ft). Check rolling torque.
Nominal range should be 0.2 - 1.0 Nm (2 - 9 lb in).
Add or remove shims to obtain the desired rolling
torque. Remove the flange, shaft and shims from
the gearbox and set aside.
Bolt PFC System Pump mounting flange (3) over
the shaft using six washers and bolts. Torque to
89 - 100 Nm (66 - 74 lb ft). Check rolling torque.
Nominal range should be 0.2 - 1.1 Nm (2 - 10 lb in).
Add or remove shims to obtain the desired rolling
torque. Remove the flange, shaft and shims from
the gearbox and set aside.
Bolt Feeder CVT Driveshaft mounting flange (4)
over the shaft using three washers and bolts.
Torque to 89 - 100 Nm (66 - 74 lb ft). Check rolling
torque. Nominal range should be 0.2 - 1.1 Nm (2 -
10 lb in). Add or remove shims to obtain the desired
rolling torque. Remove the flange, shaft and shims
from the gearbox and set aside.
Bolt Rotor and Feeder Hydro Pumps mounting
flange (6) over the shaft using six washers and
bolts. Torque to 89 - 100 Nm (66 - 74 lb ft). Check
rolling torque. Nominal range should be 0.2 - 0.9
Nm (2 - 8 lb in). Add or remove shims to obtain the
desired rolling torque. Remove the flange, shaft and
shims from the gearbox and set aside.
8. Chill bearing cups (1) in an ice bath. On the inboard
side of gearbox, press the chilled cups (1) into the
appropriate bores using the appropriate drivers.
Check to see each cup is fully seated.
POWER TRAIN - POWER COUPLING Fixed coupling
9679 1 27/05/2004
C.10.B / 12
7
20035881A5
8
20035833A5