Case IH AFX8010 Repair Manual page 2035

- wire 110 orange, separator switch S-30 X055 pin 5 to pin 2
- wire 300 orange, separator switch S-30 X055 pin 2 through connector X059 pin 3 to neutral switch
S-22 pin 1
- wire 358 orange, RC harness splice to feeder engage switch S-31 connector X056 pin 2Locate the
source of high voltage and repair.
B. If the voltage reading is 10 - 18 volts, and the diagnostic screen is still indicating voltage in excess of
18 volts, there is an internal fault in CCM1.Reload the software for CCM1. If that does not correct the
concern, replace the module.
5.
Operate the combine while monitoring the voltage on the Universal Display Plus "DIAG" screen.
A. If no high out of range voltage readings are seen, erase the error code and continue operation.
CROP PROCESSING - FEEDING Feeder housing
9712 1 27/05/2004
K.25.E / 63