Case IH AFX8010 Repair Manual page 2005

24. Using a slide hammer with a threaded 10mm
attachment remove both shafts (1) from the gearbox.
25. Be sure to rotate the shaft (1) a few degrees every
time you pull to ensure there is no binding of the
bearing in the housing.
26.
Once the shafts are removed you can use a press
to remove the bearings from the shafts.
27. Before removing the conveyor (2) and rock trap (1)
drive gears from the housing, be sure to mark the
orientation from which they were set in the housing.
CROP PROCESSING - FEEDING Feeder housing
9712 1 27/05/2004
K.25.E / 33
23
10034629A5
24
10034632A5
25
10034634
26
10034634A5