Case IH AFX8010 Repair Manual page 1513

Final drive Wheel stud - Replace (D.10.A.42.60 - F.10.A.30)
AFX8010
1. Remove the traction wheel.
2. Remove sleeve, (1), at the planetary final drive.Use
consideration that safety snap rings retain the
sleeve to the shaft, these will have to be removed.
3. Turn the output shaft of the planetary final drive until
wheel bolt,( 2) (the bolt to be replaced) is in front
of maintenance plug, (1). Remove maintenance
plug,(1)Drive out wheel bolt,(2)Insert new wheel
bolt,(2),and pull it into its place with a wheel nut.
Re-install maintenance plug,(1).
NOTE: Make sure the notch on the wheel bolt is in line
with the step on the output shaft.
TRAVELLING - FRONT AXLE
9686 1 27/05/2004
D.10.A / 33
1
ZDA4705A
2
ZDA4662A