Case IH AFX8010 Repair Manual page 1670

5. Tighten bolts (1) while making sure the combine
side door panels latch properly.
6. Install two service shields (1) and (2) by first coating
the upper and lower pivot pins with CASE AKCELA
PREMIUM GREASE EP-2. Then set the shields
down on the lower pivots and insert the pins of
plate (3) down into the top of the shield pivot tubes.
Fasten the plate to the shield support pipe flange
with two M8X25 cap screws (4) with lock washers at
both ends, and nuts. Wipe off excess lube to avoid
attracting dirt.
7. Install toolbox on bracket, engaging lip on box with
top of bracket. Then push the bottom of the box
inward until tab (1) on bracket fully enters the box.
Lock in place by lowering key (2) fully into tab.
Replace tray (3).
BODY AND STRUCTURE - SHIELD
9696 1 27/05/2004
E.20.A / 6
5
40033220A5
6
40033215A5
7
40033216A5