Case IH AFX8010 Repair Manual page 2009

9. Rotate the shafts (1) by hand to assure no binding
before proceeding further.
10. Using a caliper or dial gauge and check the position
of the gear with reference to the speed sensor
spot-facing in the housing. The dimension should
be 26. 3 mm (+0.10/-0.30mm).
11. A dial indicator can also be used instead of the
caliper.
12. Install the ball bearing (1) into the support in the
housing for the torque limiter center shaft and gear
cluster. Press the bearing into the housing until it
is seated.
CROP PROCESSING - FEEDING Feeder housing
9712 1 27/05/2004
K.25.E / 37
8
10034629A5
9
50034947
10
50034948
11
10034627A5