Case IH AFX8010 Repair Manual page 1228

4. Install the castle head lock nut and torque to 25 Nm
(18 lb ft) and then torque further until the nut can be
assembled. Use a new cotter pin.
NOTE: If the input shaft, the drive shaft and the differential
are not assembled into the gearbox, bring the shifting disc
in it's highest position by turning the shifting disc housing
out until the shifting disc blocks against the gearbox
housing.
5.
Install micro-switch bar (2), install five washers and
bolts and tighten five bolts (1). Torque the bolts to 4
- 6 Nm (3 - 4 lb ft).
6. Install indicator plate (2) and tighten nut (1) to a
torque of 8 - 12 Nm (71 - 106 lb in).
7.
Apply Loctite 573 following around the mating
surface and around the bolt holes. Spread evenly
and wipe off the excess.
POWER TRAIN - TRANSMISSION Mechanical
9680 1 27/05/2004
C.20.B / 38
4
3349a
5
3330a
6
3329a
7
3351a