Table of Contents
Advertisement
A.
If there is no continuity to ground, there is a short to ground in the main frame (MF) harness between
connector X011 and connector X008 wire 1051 white. Locate the short and repair.
B.
If there is continuity to ground, there is a short to ground in the front frame (FF) harness between
connector X008 and connector X020 pin J3-21 wire 1051 white. Locate the short and repair.
7.
Use a multimeter to check for continuity between the harness end of connector X402 pin A and chassis
ground. There should not be continuity to ground.
A.
If there is continuity to ground, continue with step 8.
B.
If there is no continuity to ground, continue with step 10.
8.
Disconnect connector X011. Use a multimeter to check for continuity between the main frame (MF) harness
end of connector X011 pin 23 and chassis ground. There should not be continuity to ground.
A.
If there is no continuity to ground, there is a short to ground in the gearbox (GB) harness between
connector X011 and connector X402 wire 1050 white.Locate the short and repair.
B.
If there is continuity to ground, continue with step 9.
9.
Disconnect connector X008. Use a multimeter to check for continuity between the front frame (FF) harness
end of connector X008 pin 23 and chassis ground. There should not be continuity to ground.
A.
If there is no continuity to ground, there is a short to ground in the main frame (MF) harness between
connector X011 and connector X008 wire 1050 white. Locate the short and repair.
B.
If there is continuity to ground, there is a short to ground in the front frame (FF) harness between
connector X008 and connector X020 pin J3-31 wire 1050 white. Locate the short and repair.
10.
Visually inspect the harness and connectors for damage, bent or dislocated, corroded terminals, or broken
wires.
A.
If no damage is found, erase the fault code and continue operation.
CROP PROCESSING - FEEDING Feeder housing
9712 1 27/05/2004
K.25.E / 83
Advertisement
Chapters
Table of Contents
Troubleshooting
