Ipv6 Router Rip - D-Link DGS-6600-48TS Manual

DGS-6604

ipv6 router rip

ipv6 router rip
no ipv6 router rip
Syntax
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 router rip
CLI Reference Guide
To enable the IPv6 RIP routing process on an interface, use the ipv6 router rip
command. To disable the IPv6 RIP routing process on an interface, use the no
form of this command.
None
Disabled
Interface configuration
The ipv6 router rip interface configuration command is used to enable IPv6 RIP
explicitly on required interfaces. In IPv4, the network network-number router
configuration command is used to implicitly specify the interfaces on which to run
IPv4 RIP.
The following example enables the IPv6 RIP routing process on VLAN 1.
ipv6 router rip
369