Chapter 94 Routing Information Protocol (Rip) Commands - D-Link xstack DGS-3620 series Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 94
enable rip
config rip [ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] | tx_mode
[disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 |
disable] | state [enable | disable] | distribute_list_in [access_list <list_name 16> | none]}(1)
config rip timers {update <sec 1-65535> | timeout <sec 1-65535> | garbage_collection <sec 1-
65535>}(1)
disable rip
show rip {ipif <ipif_name 12>}
94-1 enable rip
Description
This command is used to enable RIP for the switch. The default setting is disabled.
Format
enable rip
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable RIP:
DGS-3620-28PC:admin# enable rip
Command: enable rip
Success.
DGS-3620-28PC:admin#
94-2 config rip
Description
This command is used to configure the RIP settings for one or more IP interfaces.
Routing Information
Protocol (RIP)
Commands
1073