Connecting The Replenishment Tanks And The Silver Recovery Unit - Kodak X-Omat 2000 PROCESSOR Installation Instructions Manual

Section 6: Connecting the REPLENISHMENT TANKS and the SILVER
RECOVERY UNIT
Customers might use either REPLENISHMENT TANKS or a chemical mixing system. An example of a chemical
mixing system is a Kodak AUTOMIXER III. To install a chemical mixing system, use the INSTALLATION
INSTRUCTIONS for the system.
Caution
• The maximum height of the solutions in the REPLENISHMENT TANKS must be below the solution height in the
TANKS of the PROCESSOR.
• The maximum height of the solutions in the PROCESSOR is 97 cm (38 in.) when the PROCESSOR is installed
on the Kodak M35/M43/2000 X-Omat MOUNTING STAND.
⁄
3
[1] Use the 0.95 cm (
8
REPLENISHMENT PUMPS in the PROCESSOR.
[2] Check that the connections in the TUBING are tight.
OUT
SILVER RECOVERY UNIT
H172_0122AC
7C8771 – 04DEC98

Connecting the REPLENISHMENT TANKS and the SILVER RECOVERY UNIT

in.) TUBING to install the 2 STRAINERS between the REPLENISHMENT TANKS and the
IN
REPLENISHMENT TANKS
STRAINERS
FLOOR DRAIN
[3] If the customer has a SILVER RECOVERY UNIT,
install it.
H104_0026BCB
17