Installation Of The Interface Board - Kodak X-OMAT Multiloader 300 Installation Instructions Manual

INSTALLATION INSTRUCTIONS

INSTALLATION OF THE INTERFACE BOARD

ESD
Take proper ESD safety precautions
1. Cover the opening to the POWER SUPPLY with a sheet of paper so that nothing falls
into it.
2. Disconnect the SLAVE PROCESSOR PCB A3/2 from the socket on the MAGAZINE
INTERFACE PCB A4.
3. Rotate out PCB A4 by about 90° and install the two black PCB spacers to the PCB A4.
4. Rotate the PCB-A4 back into position.
SPACER
8/1998
figure 13-5
13-8
II 3058-4
SPACER
KODAK AG Stuttgart