Paper Jam In Puncher Unit - Toshiba e-STUDIO2330C Service Handbook

6.2.10

Paper jam in puncher unit

[E9F0] Punching jam
MJ-1030 (when MJ-6004 is installed)
1. Check if there is any paper in the finisher or the on the transport path of the equipment. Remove
it if there is.
2. Is the connector J605A on the punch controller PC board disconnected?
3. Check if the connector on the punch controller PC board is disconnected from the punch home
position sensor (PI63) or the harnesses are open circuited. Correct if any.
4. Check if the punch home position sensor (PI63) is working properly.
5. Replace the punch home position sensor.
6. Replace the punch controller PC board.
MJ-1101 (when MJ-6101 is installed)
1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the
equipment. Remove it if there is.
2. Rotate the punch motor (M3) and fix its mechanism if it does not rotate smoothly.
3. Check if the harnesses and the punch HP sensor (S4) are connected properly. Correct if any.
4. Check if the wiring of the hole punch controller PC board (HP board) and the punch motor (M3)
is proper. Correct if any.
5. Replace the punch motor (M3).
6. Replace the hole punch control PC board.
6.2.11 Other paper jam
[EAD0] Print end command time-out jam
1. Is the drum motor rotating normally?
2. Replace the SYS board.
3. Replace the LGC board.
[EAE0] Receiving time-out jam
1. Is the finisher working?
2. Check if the voltage (24V) is being supplied to the finisher.
3. Check the connection of the LGC board and IPC board.
4. Check if the harness connecting the IPC board and finisher I/F connector of the equipment side
is open circuited.
5. Check if the harness connecting the I/F connector of the finisher side and finisher controller PC
board is open circuited.
6. Replace the finisher controller PC board.
[EB30] Ready time-out jam
1. Check if there is any paper in the equipment. Remove it if there is.
2. Check if the connector on the equipment is disconnected from the finisher or the harnesses are
open circuited. Correct if any.
3. Replace the IPC board.
4. Replace the LGC board.
5. Replace the finisher controller PC board.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
6 - 48