Printer Head Cleaning Procedure
Lint from normal use of the printer may eventually collect on the printer head
and degrade print quality. Use the procedure provided in this section to clean
the printer head.
W A R N I N G
This servicing procedure is for use by qualified personnel only. To
avoid electrical shock, do not perform this procedure unless you are
qualified to do so.
C A U T I O N
Electrostatic discharge (ESD) can damage or destroy the printer. Therefore,
this procedure must always be performed at a static-safe work station.
Static-safe Work
Figure 8-1 on page 8-8 shows an example of a static-safe work station using
Station
conductive table and floor mats and wrist and heel straps. To ensure user
safety, the static-safe accessories must provide at least 1 M Ω of isolation from
ground. Refer to Table 8-1 for information on ordering static-safe accessories.
Table 8-1. Static-Safe Accessories
Agilent Part
Number
9300-0797
9300-0980
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
×
3M static control mat 0.6 m
1.2 m (2 ft
wire. (The wrist-strap and wrist-strap cord are not included. They must be
ordered separately.)
Wrist-strap cord 1.5 m (5 ft).
Maintenance
Printer Head Cleaning Procedure
×
4 ft) and 4.6 cm (15 ft) ground
8-7