Table of Contents
Advertisement
If the math expression with the corresponding CALCulate subopcode is off,
then the SENSe:DATA is used for the maximum hold operation. If the math
expression is on, the result of the math expression is used for the maximum
hold operation.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M A X i m u m [ : S TATe ] O F F | O N | 0 | 1
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M A X i m u m [ : S TATe ] ?
Related Key
Hold A None|Max|Min
:CALCulate[1|2|3|4|5|6]:MEAN[:DATA]?
Returns the arithmetic mean of the trace associated with the subopcode of the
CALCulate node.
The points of the trace are summed in linear units and the sum is divided by
the number of points. When the CALCulate[1|2|3|4|5|6]:MEAN:RANge is on,
the mean is calculated over the upper and lower X-axis range limits. If the
CALCulate[1|2|3|4|5|6]:MEAN:RANge is off, the mean is calculated over the
entire trace. Sending this query when the CALCulate[1|2|3|4|5|6]:MEAN:STATe
is off will generate a "Settings conflict" error. The MEAN calculation is per-
formed at the end of sweep. Sending this query when the instrument is in the
middle of a sweep will return the MEAN calculated for the previous sweep.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M E A N [ : D ATA ] ?
:CALCulate[1|2|3|4|5|6]:MEAN:RANGe:LOWer?
Returns the lower X-axis limit for the trace mean range calculation. The range
used for the trace mean range is the same range used for the marker search
range.
The return value is in meters, unless the span is set to zero, in which case the
return value is in seconds.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M E A N : R A N G e : L O We r ?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Programming Commands
CALCulate Subsystem Commands
6-59
Advertisement
Table of Contents
