Table of Contents
Advertisement
W A R N I N G
C A U T I O N
Static-safe Work
Station
Maintenance
Printer Head Cleaning Procedure
Printer Head Cleaning Procedure
Lint from normal use of the printer may eventually collect on the printer head
and degrade print quality. Use the procedure provided in this section to clean
the printer head. Also
This servicing procedure is for use by qualified personnel only. To
avoid electrical shock, do not perform this procedure unless you are
qualified to do so.
Electrostatic discharge (ESD) can damage or destroy the printer. Therefore,
this procedure must always be performed at a static-safe work station.
Figure 6-1 on page 6-5
conductive table and floor mats and wrist and heel straps. To ensure user
safety, the static-safe accessories must provide at least 1 M Ω of isolation from
ground. Refer to
Table 6-1
Table 6-1. Static-Safe Accessories
Agilent Part
Description
Number
9300-0797
3M static control mat 0.6 m
wire. (The wrist-strap and wrist-strap cord are not included. They must be
ordered separately.)
9300-0980
Wrist-strap cord 1.5 m (5 ft).
6-4
refer to "Changing the Printer Paper" on page
shows an example of a static-safe work station using
for information on ordering static-safe accessories.
×
1.2 m (2 ft
6-2.
×
4 ft) and 4.6 cm (15 ft) ground
Advertisement
Table of Contents
