Table of Contents
Advertisement
Table 7-8. Application-Specific Warnings (3 of 6)
Error Number
8014
8015
8016
8017
8018
8019
8020
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Error Description [description/explanation/examples]
desc = "Print statement ignored: no path is specified"
help = "The PRINT statement needs to be after a PATH statement to indicate
which PATH data is to be printed. The PRINT statement at the line number
specified came before any PATH statement. This PRINT statement will not
trigger any printouts."
desc = "DEFAULT cannot be used for a parameter."
help = "A parameter cannot be specified as DEFAULT. The parameter needs to
be either a previously defined variable name or an actual value. The bad
parameter was found on the line number specified. The number in the
parentheses is the number of the parameter causing the problem."
desc = "A duplicate command is in the spec file."
help = "Certain commands should be used only once in the specification file. The
duplicate command was found on the line number specified. The command in
the parentheses is the duplicate."
desc = "A required command is missing from the spec file."
help = "Certain commands must be used in the specification file. The missing
command is listed in the parentheses. This command should be used only once
in the file."
desc = "The normalization interval limited to maximum."
help = "The normalization interval has a maximum value of 24 and a minimum
value of 0.1 hours. The interval specified in the specification file is outside this
range. The specification file can still be used but the calibration interval will be
24 hours."
desc = "The spec file could not be loaded."
help = "The application found a problem with the specification file. Possible
causes can include the following: the file is incompatible with the application
the file is from a previous version of the application the file was corrupted. The
file with the problem is specified within the parentheses. Try re-importing the
specification file."
desc = "The default spec file was loaded."
help = "The default specification file for the application was loaded. This is done
when the application is first started or if a problem occurred when trying to load
another specification file. Refer to the previous warnings for information on any
problems loading another file."
Status Listings
Application-Specific Warnings
7-33
Advertisement
Table of Contents
