Table of Contents
Advertisement
Function Reference
Marker Search Menu
Marker Search Menu
Accesses the following marker peak and pit search functions:
• Select peak or pit search mode
• Perform peak or pit search
• Select next peak down, left or right
• Select next pit up, left or right
• Select active markers
The active markers can also be turned on or off from this menu, which avoids
returning to the Marker menu to change markers.
Key Path
Markers > More Marker Functions > Marker Search Menu
Marker Search Threshold Value (Marker Setup Panel)
Sets the amplitude threshold value used for limiting the marker search func-
tion. Any peaks below the threshold value will be ignored. When the Marker
Search Threshold is on, a dotted line is shown on the display at the threshold
level. The Use Marker Search Threshold function in the Marker Setup Panel
must be enabled or the Marker Search Threshold Value will be greyed out.
Key Path
Markers > Marker Setup > Marker Search Threshold Value
Related Functions
Pit Excursion, Peak Excursion, Marker Search Threshold
Remote
CALCulate:THReshold
Commands
CALCulate:THReshold:STATe
Marker Setup
Accesses a menu for making changes to default marker settings. From the
setup panel you can make changes to marker units, interpolation methods,
peak and pit excursion, marker search threshold, and peak search at end of
each sweep.
2-28
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
