Table of Contents
Advertisement
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:AOFF
Turns off all markers and marker functions.
Note
Going to zero span will turn off all markers. This is because markers are referenced to a
particular time or wavelength not a particular display position. Going out of zero span
will restore the markers to the state they were in before going to zero span. Changing to
or from zero span changes the fundamental units for the X-axis.
If no marker number is given in the following marker commands, the command is inter-
preted as referring to marker number 1. For example, CALC:MARK ON is equivalent to
CALC:MARK1 ON.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M a r k e r [ 1 | 2 | 3 | 4 ]
Related Keys
Active Marker 1|2|3|4|OFF
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:FUNCtion:BWIDth|
BANDwidth:INTerpolate
Turns the bandwidth marker interpolation on or off.
When interpolation is on, the bandwidth markers will be placed at the exact
number of dB (NDB) setting from the normal marker if the trace data allows.
The position of the marker will be linearly interpolated between two true trace
data points. The default state is on. If interpolate is off, for negative NDB val-
ues, the bandwidth markers will be at values closest to and more negative than
the NDB value. For positive NDB values, the bandwidth markers will be at val-
ues closest to and more positive than the NDB values. This will typically result
in a wider bandwidth measurement.
This is a global setting and controls the interpolation state for all four band-
width markers.
Syntax
:CALCulate[1|2|3|4|5|6]:Marker[1|2|3|4]:FUNCtion:BWIDth|BANDwidth
:CALCulate[1|2|3|4|5|6]:Marker[1|2|3|4]
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
: I N Te r p o l a t e O F F | O N | 0 | 1
| B A N D w i d t h : I N Te r p o l a t e ?
Programming Commands
CALCulate Subsystem Commands
:AOFF
: F U N C t i o n : B W I D t h
6-33
Advertisement
Table of Contents
