Table of Contents
Advertisement
:TRACe[:DATA]:X[:WAVelength]:SSTop
Sets the start and stop values for the X-axis data for the trace.
The first <numeric_value> corresponds to the start, and the second corre-
sponds to the stop. If the stop value is a shorter wavelength than the start
value, a "Data out of range" error will be generated. The X-axis data will be
evenly spaced points from start to stop. The number of points is determined
by the TRACe:POINts setting. If the trace has an expression defined, this
expression will be cleared when the X-axis start/stop is changed.
Changing the X-axis data in a trace used in an expression
(CALCulate:MATH:EXPRession) by another trace may cause an error in the
expression if the X-axis data in the operands of the expression no longer
match.
Syntax
: T R A C e [ : D ATA ] : X [ : WAVe l e n g t h ] : S S To p
:TRACe[:DATA][:Y]?
Returns the Y-axis data points for the trace.
The units are determined by the definition of the trace. The trace data format
used in the command is determined by the FORMat subsystem.
Syntax
: T R A C e [ : D ATA ] [ : Y ] ? T R A | T R B | T R C | T R D | T R E | T R F
:TRACe[:DATA][:Y][:POWer]
Sets the normalization trace and trace data.
The units are determined by the definition of the trace. The trace data format
used in the command is determined by the FORMat subsystem.
Syntax
: T R A C e [ : D ATA ] [ : Y ] [ : P O We r ] T R A | T R B | T R C | T R D | T R E | T R F
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
T R A | T R B | T R C | T R D | T R E | T R F,
< n u m e r i c _ v a l u e > [ M | U M | N M | P M | A | H Z | K H Z | M H Z | G H Z | T H Z ] ,
< n u m e r i c _ v a l u e > [ M | U M | N M | P M | A | H Z | K H Z | M H Z | G H Z | T H Z ]
N O R M 1 | N O R M 2
N O R M 1 | N O R M 2
Programming Commands
TRACe Subsystem Commands
6-103
Advertisement
Table of Contents
