Table of Contents
Advertisement
The range used for the trace mean range is the same range used for the
marker search range. Changing the range with this command will change all
four ranges.
Sending this command when the instrument is in a zero span will generate a
"Settings conflict" error. Default units for the parameter are meters. Fre-
quency units are also allowed.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M E A N : R A N G e : L O We r [ : WAVe l e n g t h ]
:CALCulate[1|2|3|4|5|6]:MEAN:RANGe[:STATe]
Turns the trace mean calculation range
Turning the calculation range
CALCulate[1|2|3|4|5|6]:MEAN:STATe
specified via its subopcode). There is a single range controlling the total
power integration, the trace mean range, and the marker search range, but
there are two independent state settings for limiting the trace mean calcula-
tion and the marker search.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M E A N : R A N G e [ : S TATe ] O F F | O N | 0 | 1
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M E A N : R A N G e [ : S TATe ] ?
:CALCulate[1|2|3|4|5|6]:MEAN:RANGe:UPPer?
Returns the upper X-axis limit for the trace mean range calculation.
The range used for the trace mean range is the same range used for the total
power calculation and the marker search range.
The returned value is in meters, unless the span is set to zero, in which case
the returned value is in seconds.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M E A N : R A N G e : U P P e r ?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
< n u m e r i c _ v a l u e > [ M | U M | N M | P M | A ]
ON
Programming Commands
CALCulate Subsystem Commands
or
for all traces.
ON
OFF
will also turn the
for the specified trace (the trace is
ON
6-61
Advertisement
Table of Contents
