Table of Contents
Advertisement
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:SRANge:LOWer[:WAVelength]
Sets the lower limit for the marker search range.
Setting this value when :CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:
SRANge:STATe is off will automatically turn :CALCulate[1|2|3|4|5|6]:
MARKer[1|2|3|4]:SRANge:STATe on. The range used for the marker search
range is the same range used for the trace mean range. Sending the command
when the instrument is in a zero span will generate a "Settings conflict" error.
Default units for the parameter is in meters; frequency units are allowed.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M a r k e r [ 1 | 2 | 3 | 4 ] : S R A N g e : L O We r
Wavelength Marker 1
Related Key
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:SRANge:[:STATe] OFF|ON|0|1
Turns the search range on or off for all the markers. When the search range is
on, all the marker maximum/minimum searches will be within the upper and
lower wavelength range. Although these is a single range controlling the total
power integration, the marker search range, the mean calculation, and the
wavelength sweep range, there are four independent state settings for limiting
the total power integration, the marker search, the mean calculation, and the
wavelength sweep to the range. If all four states for the total power integra-
tion, the marker search, the mean calculation, and the wavelength sweep
range are off, setting:CALCulate[1|2|3|4|5|6]:Marker[1|2|3|4]:SRANge:STATe to
on will initialize the lower range to
and the upper range to
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M a r k e r [ 1 | 2 | 3 | 4 ] : S R A N g e [ : S TATe ]
Related Key
Search Limit On Off
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[ : WAVe l e n g t h ] < p a r a m >
span
start
+
----------- -
3
span
×
----------- -
start
+
2
.
3
O F F | O N | 0 | 1
Programming Commands
CALCulate Subsystem Commands
6-51
Advertisement
Table of Contents
