Printer Head Cleaning Procedure - Agilent Technologies 8614 B Series User Manual

Maintenance

Printer Head Cleaning Procedure

Printer Head Cleaning Procedure
Lint from normal use of the printer may eventually collect on the printer head and degrade print
quality. Use the procedure provided in this section to clean the printer head. Also
"Changing the Printer Paper" on page
W A R N I N G This servicing procedure is for use by qualified personnel only. To avoid electrical shock, do not
perform this procedure unless you are qualified to do so.
C A U T I O N Electrostatic discharge (ESD) can damage or destroy the printer. Therefore, this procedure must
always be performed at a static-safe work station.
Static-safe Work Station Figure 6-1 on page 6-5
and floor mats and wrist and heel straps. To ensure user safety, the static-safe accessories must
provide at least 1 MW of isolation from ground. Refer to
static-safe accessories.
Table 6-1. Static-Safe Accessories
6-4
shows an example of a static-safe work station using conductive table
Agilent Part Number Description
9300-0797
3M static control mat 0.6 m
(The wrist-strap and wrist-strap cord are not included. They must be ordered
separately.)
9300-0980 Wrist-strap cord 1.5 m (5 ft).
6-2.
Table 6-1
x x
1.2 m (2 ft 4 ft) and 4.6 cm (15 ft) ground wire.
refer to
for information on ordering