Table of Contents
Advertisement
UNIT Subsystem Commands
Default values are defined, where applicable, for each SCPI command. The
UNIT subsystem provides a mechanism to change the default values. The
units selected apply to the designated command parameters for both com-
mand and response.
The commands in this subsystem have the following command hierarchy:
:UNIT
:POWer DBM|W
:RATio DB|LINear|AUTO
:UNIT:POWer
Selects the units in dBm or mW for the measured value.
Syntax
: U N I T: P O We r D B M | W
(Amplitude Setup) Amplitude Units
Related Key
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Programming Commands
UNIT Subsystem Commands
6-107
Advertisement
Table of Contents
