Table of Contents
Advertisement
Programming Commands
CALCulate Subsystem Commands
:CALCulate[1|2|3|4|5|6]:MINimum[:STATe]
Turns minimum hold for a trace on or off.
The minimum hold operation compares the current amplitude value of each
point on a trace in the current sweep to the corresponding point detected dur-
ing the previous sweep, then stores the minimum value. The
CALCulate[1|2|3|4|5|6]:AVERage, CALCulate[1|2|3|4|5|6]:MAXimum, and
CALCulate[1|2|3|4|5|6]:MINimum states are mutually exclusive. Each trace can
have only one of these functions on at a time. Turning CALCulate[1|2|3|4|5|6]:
MINimum on will automatically turn CALCulate[1|2|3|4|5|6]:AVERage and
CALCulate[1|2|3|4|5|6]:MAXimum off. Each trace can have a different
CALCulate block turned on. For example, CALCulate1:MAXimum on,
CALCulate2:MINimum
mum hold, trace B in minimum hold, and trace C in trace average mode.
If the math expression with the corresponding CALCulate subopcode is
then the SENSe:DATA is used for the minimum hold operation. If the math
expression is
hold operation.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M I N i m u m [ : S TATe ] O F F | O N | 0 | 1
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M I N i m u m [ : S TATe ] ?
Hold A None|Max|Min
Related Key
:CALCulate[1|2|3|4|5|6]:OFFset <param>
Sets the trace offset for a trace.
The Trace Math menu includes a "per trace" offset for each trace. The offset
for each trace can be set independently. The units are determined by the
amplitude units setting. When the amplitude units are set to "auto", the units
will be in dB in log display mode and "X" (unitless ratio) in linear display
mode.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : O F F s e t < p a r a m >
Related Key
Trace A Offset
6-64
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
, CALCulate3:AVERage
ON
, the result of the math expression is used for the minimum
ON
will put trace A in maxi-
ON
,
OFF
Advertisement
Table of Contents
