Table of Contents
Advertisement
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M a r k e r [ 1 | 2 | 3 | 4 ] : S R A N g e : U P P e r : T I M E
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:SRANge:UPPer[:WAVelength]
Sets the upper limit for the marker search range.
Setting this value when :CALCulate[1|2|3|4|5|6]:Marker[1|2|3|4]:SRANge:STATe
is off will automatically turn :CALCulate[1|2|3|4|5|6]:Marker[1|2|3|4]:
SRANge:STATe on. The range used for the marker search range is the same
range used for the total power calculation, the trace mean range, and the
wavelength sweep range. Sending the command when the instrument is in a
zero span will generate a "Settings conflict" error. Default units for the param-
eter is in meters; frequency units are allowed.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M a r k e r [ 1 | 2 | 3 | 4 ] : S R A N g e : U P P e r
Related Key
Wavelength Marker 2
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4]:SRLevel
Sets the reference level to the amplitude of the marker.
Syntax
: C A L C u l a t e [ 1 | 2 | 3 | 4 | 5 | 6 ] : M A R K e r [ 1 | 2 | 3 | 4 ] : S R L e v e l
Marker to REF LEVEL
Related Key
:CALCulate[1|2|3|4|5|6]:MARKer[1|2|3|4][:STATe]
Turns a particular marker
If no number is given for the MARKer node, 1 is assumed. (For example, :CAL-
Culate[1|2|3|4|5|6]:MARKer[1|2|3|4] on will turn marker 1 on.) The marker will
be placed on the trace determined by the :CALCulate[1|2|3|4|5|6]:
MARKer[1|2|3|4]:TRACe command. If no trace is specified, the default trace is
trace A. The marker will be placed at the center wavelength. Turning a marker
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
< p a r a m >
[ : WAVe l e n g t h ] < p a r a m >
or
ON
CALCulate Subsystem Commands
.
OFF
Programming Commands
6-53
Advertisement
Table of Contents
