Din Rail Mounting - YASKAWA MP3000 Series Setup Manual

2.1.2

DIN Rail Mounting

This section describes how to install the Controller by mounting it on DIN rail.
DIN Rail Types and the Spacer
Various types of DIN rails are available with a 7-mm to 15-mm gap from the mounting surface
as shown on the left in the following figure. If you mount an MP3200 using a DIN rail with a 10-
mm or larger gap, install a spacer on the back of and near the bottom of the MP3200, as
shown on the right side of the following figure, to protect it from vibration and shock.
Distance from mounting surface: 7.5 to 15 mm
Installation plate
DIN rail
Procedure for Mounting to a DIN Rail
1.
Attach the DIN rail to the control panel and secure it in place.
Securing the DIN Rail
Secure the DIN rail at a pitch of 150 mm or less, as shown in the following figure.
Important
2.
Hook the MP3200 to the top of the DIN rail (a in the figure), and then press the Controller
toward the mounting surface (b in the figure) to secure it in place.
DIN Rail with a 10-mm Gap
150 mm max.
2.1 MP3200 Installation

2.1.2 DIN Rail Mounting

DIN rail
Spacer
150 mm max.
2
2-7