YASKAWA MP3000 Series Setup Manual page 48

2.1 MP3200 Installation
2.1.6 Battery Installation and Replacement
8.
Press the connector back into the CPU Unit.
9.
Hold the connector, and while pressing it toward the CPU Unit's internal circuit board
(the board on the side of the clamp), move the Battery and the battery holder into the
CPU Unit.
Note: If this procedure is not followed, the battery leads may be pinched between the Battery and the circuit
10.
Close the battery holder and confirm that the BAT indicator on the CPU Unit is not lit.
This concludes the Battery replacement procedure.
2-20
board, causing stress on the leads. If that occurs, the battery holder will bulge after step 8 of the proce-
dure.
Press in.
2 battery leads
Lit.
Not lit.
Clamp
CPU Unit internal circuit
board (clamp side)
Move the Battery.