Device-Specific Settings; Data That Is Automatically Updated During Self Configuration - YASKAWA MP3000 Series Setup Manual

3.6

Device-specific Settings

This section describes the data that is automatically updated during self configuration, and the data
that is changed by the user.
3.6.1 Data That Is Automatically Updated during
Self Configuration
Use the following procedure to confirm the results of self configuration to make sure that the
Modules are properly assigned to the slots.
1.
Open the project file.
Click Module configuration under Setup.
2.
The Module Configuration Tab Page will be displayed as shown below.

3.6.1 Data That Is Automatically Updated during Self Configuration

3.6 Device-specific Settings

3
3-19