Removing And Attaching The Protective Covers; Exterior And Mounting Dimensions - YASKAWA CIMR-JA Series Installation & Start-Up Manual

n Multiple Drive Installation
When installing multiple drives into the same enclosure panel, mount the drives according to
Figure 2.2. When mounting drives with a minimum side-by-side clearance of 2 mm according
to Figure 2.3, derating must be considered and parameter L8-35 must be set.
Parameter List on page
A
B
2 mm
A – Line up the tops of the drives.
B – 30 mm minimum
Figure 2.3 Space Between Drives (Side-by-Side Mounting)
Note: When installing drives of different sizes into the same enclosure panel, the tops of the drives should line
up. Leave space between the top and bottom of stacked drives for cooling fan replacement if required. Using
this method, it is possible to replace the cooling fans later.
u

Removing and Attaching the Protective Covers

Refer to Electrical Installation on page
reattachment of protective covers.
u

Exterior and Mounting Dimensions

The following table matches each drive model with its appropriate drawing.
YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
197.
B
39, for information regarding the removal and
2.2 Mechanical Installation
C
C
C – 100 mm minimum
D – Airflow direction
Refer to
D
2
35