Setting A Project Password - YASKAWA MP3000 Series Setup Manual

Click the Create Button.
3.
After the Create/Open Project File message is displayed, the project file is created in the specified
folder and the created project file is displayed in the System Pane.
After you create a project file, you can perform program file operation in the Ladder and Motion
Panes.
Make the following settings after you create a project file.
• Communications settings
• Module configuration settings
Note
• System settings
• Scan settings
Information
3.3.3

Setting a Project Password

You can set a password for the project file that is currently open.
Refer to the following chapter for details.
Chapter 6 Security
If you forget the password that you set, there is no way to recover it, and it will be impossible to
open the password-protected project file. Therefore, if you set a password, make sure you do not
forget it.
Important
3.6 Device-specific Settings on page 3-19
Setting the Scan Times (page 3-48)
• Opening an Existing Project File
You can open an existing project files by dragging its icon to the window of MPE720 ver-
sion 7. Alternatively, select File − Open Project from the menu bar to display the Open
Project Dialog Box, and then select and open the project file from there.
Note: If another project file is already open in the same window, and there were changes
made to it, then performing the operation above will display a dialog box asking
whether to save the changes to the project file.
• Saving a Project File
A project file can be saved so that it overwrites the previous version. Select File − Save
Project from the menu bar. A message will be displayed asking you to wait while the
project file is being saved. The edited project file is saved by overwriting the previous ver-
sion of it. To save the project file with a different name, select File − Save as a New
Project from the menu bar.
• Closing a Project File
To close a project file, select File − Close Project from the menu bar. Alternatively,
select Close from the Project Menu on the Start Tab Page.
3.3 Creating a Project File

3.3.3 Setting a Project Password

3
3-9