YASKAWA MP3000 Series Setup Manual page 99

Precautions When Setting the Parameters
• Always save all settings to the flash memory after changing them.
• When changing the settings, be careful not to set register numbers that overlap with other
Note
Modules.
• Set I/O start and end registers even if a I/O Module is not connected to the MECHATROLINK
network.
Status Display Contents
The items displayed in the Status Column are listed below.
 Function Module Status
The following status is displayed for Function Modules.
Display
−−−−
Empty
Driving
Failure
×
Initializing
Driving Stop
3.6.1 Data That Is Automatically Updated during Self Configuration
The Function Module is not defined.
The Function Module is defined, but it is not operating correctly.
The Function Module is operating normally.
An error was detected in the Function Module.
A Function Module is operating, but it is not the Function Module that was
defined.
The Function Module is defined, but there is no Detailed Function Module Defini-
tion.
The CPU Unit is stopped (The user programs are stopped).
3.6 Device-specific Settings
Description
3
3-21