YASKAWA MP3000 Series Setup Manual page 206

 Batch Saving to USB Memory
When a save operation is performed to the USB memory device, any data that is stored on the
USB memory device will be overwritten.
Note
1.
Turn ON the power supply to the CPU Unit/CPU Module.
2.
Make sure the security password has not been set for the CPU Unit/CPU Module. Oth-
erwise, any attempts to perform a batch save will fail. Refer to the following section for
details on removing the security password.
Deleting a Password (page 6-8)
3.
Insert the USB memory device that contains the application data to transfer into the
USB connector on the CPU Unit/CPU Module.
4.
Set the INIT pin on the mode switch 1 on the CPU Unit/CPU Module according to the
register type to save.
Registers to
Save
M registers Transferred.
G registers Transferred.
S registers Transferred.
I registers Transferred.
O registers Transferred.
C registers
# registers Always transferred regardless of DIP switch setting.
D registers
5.
Press and hold the STOP/SAVE switch on the CPU Unit/CPU Module for at least two
seconds. The batch save operation starts.
If the save operation fails, an error code will be displayed on the CPU Unit/CPU Module.
Information
Refer to the following manual to troubleshoot the problem, then perform the batch save
again.
MP3000 Series MP3200/MP3300 Troubleshooting Manual (Manual No.: SIEP C880725 01)
INIT Switch Setting
OFF
Not transferred.
Not transferred.
Not transferred.
Not transferred.
Not transferred.
4.6 Data Transfer without Using the MPE720
4.6.1 Using USB Memory
ON
4
4-73