YASKAWA MP3000 Series Setup Manual page 60

2.2 MP3300 Installation
2.2.4 Replacing and Adding Optional Modules
4.
Pull the top of the Optional Module panel toward you and remove it. A notch on the
Optional Module will be visible from the gap with the panel. Hook the round knob on the
battery cover into the notch in the Optional Module.
5.
Hold the center of the battery cover, and turn it around the round knob while pushing it
toward the back to disconnect the Module from the Mounting Base connectors. Then,
pull the Module forward.
6.
Hold the Optional Module at the top and bottom and pull it straight out. Hold the edges
of the Module and avoid touching the components on the Module.
Note: Put the Module that you removed into the bag that was supplied when you purchased it and store the
2-32
Module in this bag.