Installing Optional Modules - YASKAWA MP3000 Series Setup Manual

2.1.4

Installing Optional Modules

Use the following procedure to install Optional Modules.
1.
Hold the top and bottom of the Optional Module to be installed, line up the Module with
the left side of the guide rail inside the option slot, and then insert the Module straight
in.
The FG bar inside and on the bottom may be damaged if the Module is not inserted along the
guide rail.
Note
2.
After the Optional Module is completely inserted, place your hand on the front of the
Optional Module and press the Optional Module firmly until it mates with the Mounting
Base connectors in the Unit. The front of the Optional Module and the tabs will be
aligned if the Optional Module has been installed properly.
3.
Place the hole on the bottom of the panel of the Optional Module onto the tab on the
bottom of the Unit. Next, hook the hole at the top of the panel of the Optional Module
onto the tab on the Unit.
This completes the installation procedure.
Always use Option Covers (model: JEPMC-OP2300) to cover unused slots.
Note
2.1 MP3200 Installation

2.1.4 Installing Optional Modules

2
2-11