Starting The Test Run And Selecting The Axis - YASKAWA MP3000 Series Setup Manual

3.7.2

Starting the Test Run and Selecting the Axis

Open the Test Run Dialog Box and specify the SERVOPACK axis to test. Use the following pro-
cedure to set the axis.
Double-click Test run under Axis configuration in the System Pane. Alternatively, click
1.
the Test Run Button on the Start Tab Page.
The Test Run Warning Dialog Box will be displayed.
Check the contents of the Warnings Dialog Box, and then click the Agree Button.
2.
Next, the Test Run Dialog Box and the Axis Selection Dialog Box will be displayed.
3.
Select the axis you want to test from the axis configuration tree in the Axis Selection
Dialog Box, then click the OK Button.
Information
The information assigned in the Module configuration definition will be displayed in the
Axis Selection Dialog Box.
3.7.2 Starting the Test Run and Selecting the Axis
3.7 Test Run
3
3-53