General Procedure - Siemens RUGGEDCOM WIN5158 Installation Manual

Hide thumbs Also See for RUGGEDCOM WIN5158:

User manual (108 pages)

Table Of Contents

Table of Contents

Chapter 2

Installing the Subscriber Station

IMPORTANT!

This product should be installed in a restricted access location where access can only be gained by

authorized personnel who have been informed of the restrictions and any precautions that must be

taken. Access must only be possible through the use of a tool, lock and key, or other means of security,

and controlled by the authority responsible for the location.

IMPORTANT!

Install equipment in accordance with the electrical code relevant to the country of installation, such as:

• the National Electrical Code (NEC), ANSI/NFPA 70

• the Canadian Electrical Code (CEC), Part 1, CSA C22.1

• the National Electrical Safety Code IEEE C2 (when applicable)

Unless marked or otherwise identified, the Standard for the Protection of Electronic Computer/Data

Processing Equipment, ANSI/NFPA 75, also applies.

IMPORTANT!

Outdoor exposed communication lines longer than 40 m (140 ft) must be considered as TNV-1 circuits.

The installer must make sure the power supply and network ports are designed for full compliance with

the standards for TNV-1 telecommunication networks.

CONTENTS

•

Section 2.1, "General Procedure"

•

Section 2.2, "Unpacking the Subscriber Station"

•

Section 2.3, "Required Tools and Materials"

•

Section 2.4, "Site Preparation and Precautions"

•

Section 2.5, "Installing the Subscriber Station in Hazardous Locations"

•

Section 2.6, "Mounting the Subscriber Station"

•

Section 2.7, "Installing the Antennas"

•

Section 2.8, "Grounding the Subscriber Station"

•

Section 2.9, "Connecting Power and Data"

•

Section 2.10, "Weatherproofing the Subscriber Station"

•

Section 2.11, "Configuring the Subscriber Station"

Section 2.1