Configuring Stp/Rstp/Mstp; Activating Stp/Rstp/Mstp; Root Switch; Path-Cost - Siemens S223 User Manual

Siemens single-board fast ethernet switch operators user manual
Table of Contents

Advertisement

UMN:CLI
8.3.5
8.3.5.1
8.3.5.2
8.3.5.3
212

Configuring STP/RSTP/MSTP

To configure STP and RSTP, use the following steps.
Step 1
Decide STP mode using the stp force-version {stp | rstp} command.
Step 2
Activate MST daemon using the stp mst enable command.
Step 3
Configure detail options if specific commands are required.

Activating STP/RSTP/MSTP

To enable/disable STP, RSTP, and MSTP in the force-version, use the following command.
Command
stp mst { enable | disable }
Even though STP function does not operated, loop event does not occur in a switch
which belongs to the non-dual path LAN environment.

Root Switch

To establish STP, RSTP, or MSTP function, first of all, root switch should be decided. In
STP or RSTP, it is named as root switch and in MSTP it is as IST root switch. Each switch
has its own bridge ID, and root switch on same LAN is decided by comparing their bridge
ID. However, the user can modify root switch by configuring priority for it. The switch hav-
ing the lowest priority is decided as root switch.
To change root switch by configuring priority for it, use the following command.
Command
stp mst priority MSTID-RANGE
<0-61440>
no stp mst priority MSTID-
RANGE

Path-cost

After deciding root switch, you need to decide to which route you will forward the packet.
To do this, the standard is path-cost.
Generally, path cost depends on transmission speed of LAN interface in the switch. The
following table shows path cost according to transmit rate of LAN interface.
You can use same commands to configure STP and RSTP, but their path-costs are to-
tally different. Please be careful not to make mistake.
SURPASS hiD 6615 S223/S323 R1.5
Mode
Bridge
Enables/disables STP, RSTP or MSTP function.
Mode
Configures the priority of the switch:
MSTID-RANGE: select instance number 0.
0-61440: priority value in steps of 4096 (default: 32768)
Bridge
Clears the Priority of the switch, enter the instance
number.
User Manual
Description
Description
A50010-Y3-C150-2-7619

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S323Surpass hid 6615 s223Surpass hid 6615 s323 r1.5

Table of Contents